Polyethylene trash chutes are the choice of suppliers & contractors throughout North America. Superb ease-of-use and durability provide a quick, clean, & safe solution. Our designs have been perfected to provide you with the right tool for debris removal.
IDEAL FOR: Builders • Roofers • Scaffolders • Masons • Demo Contractors • Renovators
Sections are tapered tubes that attach quickly & easily to one another using built-in cable assemblies. Create chutes up to 200 ft. in length. Entry sections allow debris to be cleared from any floor level. Use Chute Hoists to install and support the chute.
4 foot tall (because linked sections overlap a little, 3 sections provide 10 ft. of drop).
slightly tapered (only 1 inch taper - tight fit minimizes airborne dust).
equipped with safe & strong cable linking hardware.
branded with your company name.
outstandingly resistant to abrasion, chemicals and cold.
lightweight, safe, flexible, and quiet in use.
made from yellow UV treated plastic.

The two SLPâ„¢ poles extend from 4' 9" to 12 feet.
The poles can be placed 8 to 10 feet apart. If there is any significant air movement that pushes the plastic you will want to pull them in closer together.
The GripDiskâ„¢ slide stoppers should always be used especially on hard surfaces. Two GripDiskâ„¢ slide stoppers come in every SLP2 package.
Plastic sheeting is not included.
2 spring loaded poles
2 grip disks
2 tethers

The four SLP poles extend from 4' 9" to 12 feet.
To use the Foam Rails you will need to remove the head of the SLP pole by pulling the head straight off. Then snap the Foam Rail onto the pole. Each foam rail is five feet long.
The GripDisk should always be used especially on hard surfaces.
Plastic sheeting is not included.
4 SLPs
2 Foam Rail cross bars
4 Grip Disks
2l standard zippers
1 Carry bag

THESE ARE GREAT FOR FRAMING WALLS THEY HAVE SWIVELING ENDS FOR EASY USE AND ARE AMERICAN MADE. EACH SOLD SEPERATELY

HEAVY DUTY EXTENSION CORD 50FT.
12 GAUGE

16 ga galvanized steel frame and legs

Legs angle two directions for increased stability

Spring-loaded leg locking pins

Non-skid nylon feet

Compatible accessories available

1000 lbs. capacity per pair

* Cannot be shipped UPS

WOOD TOPS SOLD SEPERATELY
16 ga galvanized steel frame and legs

Legs angle two directions for increased stability

Spring-loaded leg locking pins

Non-skid nylon feet

Compatible accessories available

1000 lbs. capacity per pair

* Cannot be shipped UPS

adjustable Wall
Brace will position the
top of your walls, but how about the bottom plate? Tap the sill plate out with a sledge hammer, or climb a ladder to sledge hammer the plate in? No way! The Qual-Craft Pee-Vee works on the same principal as the woodsman’s pee-vee, it uses leverage to get the job done. The Pee-Vee provides both pushing and pulling power so you can move the sill plate in or out to accomplish proper alignment. To use the Pee-Vee, set the leverage bar into the floor, and the jaw into the sill plate. Then move the lever bar in the appropriate direction to move the sill plate in or out. So much easier and precise than hammering. The Pee-Vee comes in two sizes to accommodate the jobsite requirements for sill plate adjustments

Made of tubular steel with tough blue powder coat. Can be bolted through up to an 8" thick wall. The bracket has a 42" length out from the wall, 23" vertical support with steel angle support. A 5/8" by 11 X 11 threaded rod is used and the threaded handle is included into the price. Guard rail bracket post is available.